Avaya Trimline Telephone User Manual


 
5
To Install Your Wall Telephone
1. Align the wall phone plug with the jack, then line up the hole in the back
of the telephone set with the rivets on the wall outlet plate. Push in and
slide the telephone down into place (Figure 4).
2. Plug one end of the coiled handset cord into the jack in the handset.
Push the plug in until it clicks.
3. Plug the other end of the cord into the jack in the bottom of the wall
base. Push the plug in until it clicks.
4. Adjust the ringer volume switch on the upper right side of the telephone
to the desired setting.
For All Telephones
Place the number card on your telephone following the instructions on the
back of the number card label.
FIGURE 4 Wall Telephone Installation
To Remove Your Telephone
1. To disconnect or remove your telephone reverse the installation
procedures. To remove any modular plug, squeeze the clip of the plug
and pull it out of the jack.
2. To disconnect a wall set, slide the set up to lift it off the rivets and pull it
away from the wall.