Filter
Top Products
3
Installing and Replacing Batteries
The Avaya 16xx/96xx Amplified Speech Handset ships with 2 AAA-size alkaline
batteries. When installing and/or replacing batteries follow the instructions below.
1. Verify that you have two new AAA-size batteries and unplug the handset from the
cord.
2. Remove the battery cover by using your fingernail, press down on the top of the
battery compartment cover and pull out away from handset.
3. Insert the right-side battery, positive end facing down.
4. Insert the left-side battery, positive end facing up.
Note: Diagram printed on bottom of battery compartment shows proper battery
placement.
5. Replace battery cover.
Always remove old, weak, or worn-out batteries promptly and safely by unplugging
the handset from the cord and then removing the batteries. Recycle or dispose of
them in accordance with Local and National Disposal Regulations. Install new
batteries as shown in the figures above.
Setting the Mode
Before using the handset, set the slide switch, located inside the battery
compartment to the mode you want. The figure below shows the slide switch set to
Mode 1 (the ‘Push to Amplify’ mode).