Filter
Top Products
The Dual Battery Charger Stand
Issue 1 July 2003
11
The Dual Battery Charger Stand
The Dual Battery Charger Stand is a two-slot desktop charger designed to charge
the Nickel Metal Hydride (NiMH) Battery Packs required to operate wireless
telephones. Full charging is accomplished in approximately two hours.
Only NiMH Battery Packs with a YELLOW label on the handset contact side may
be charged in the Dual Battery Charger Stand. Older Battery Packs with a
GREEN label will not charge. If the indicator light is fast flashing with a Battery
Pack or handset in the slot, check to make sure the Battery Pack has a YELLOW
label.
The Dual Battery Charger should not be used to charge Nickel-Cadmium (NiCd)
Battery Packs.
When you are not using your wireless telephone, keep it turned off and in the
Stand.
Do not place anything in the Dual Battery Charger other than the wireless
telephone. You might damage the contacts. Bent contacts can keep the wireless
telephone from charging.
Using the Dual Battery Charger
Place the Dual Battery Charger on a flat, horizontal surface.
The user must end any call in progress by pressing the END key on the wireless
telephone before placing the handset into the Charger. Place the wireless
telephone in the front compartment facing forward. It may be on or off during
charging. A single spare Battery Pack may be placed in the rear slot. Either slot
can be chosen to take priority. The first Battery Pack placed into either slot is
charged first.
There are two indicator lights, one for each charging slot. A solid light indicates
the Battery Pack in the corresponding slot is charging. A solid dim light indicates
that the slot is waiting to charge while the Battery Pack in the other slot is
charging. The light turns off when the charger is finished charging the Battery
Pack. A fast flash indicates the Battery Pack is not charging and must be
replaced. If the light is off, it indicates that the slot is empty, not charging or the
unit is powered off.
Cleaning the Dual Battery Charger
Clean the Dual Battery Charger by wiping the surface with a clean,
water-dampened cloth or paper towel. A mild detergent solution may be used. Be
sure to wipe away any detergent residue with a plain water-dampened cloth. DO
NOT IMMERSE THE DUAL BATTERY CHARGER IN WATER OR OTHER
LIQUID.