Avaya 1230 IP Phone User Manual


 
Installing your Avaya 1230 IP Deskphone
37
Attaching the foot stand (optional)
Attach the foot stand in the appropriate slots, depending on the desired
angle for your IP Deskphone. If you insert the foot stand into the upper
slots, your IP Deskphone sits at a 25-degree angle. If you insert the foot
stand into the lower slots, your IP Deskphone sits at a 55-degree angle.
If you install your IP Deskphone on a wall, do not attach the foot stand.
1. Align the bottom tabs on the foot stand with the position 1 slots or the
position 2 slots on the back of your IP Deskphone.
In position 1 the IP Deskphone sits at a 25-degree angle.
In position 2 the IP Deskphone sits at a 55-degree angle.
Figure 4 on page 36 shows the slots on the back of the IP
Deskphone.
2. Press the foot stand into the slots until it snaps into place.
Connecting the handset
Use the following procedure to connect the handset to the Avaya 1230 IP
Deskphone.
1. Plug the end of the handset cord with the short straight section into
the handset.
2. Plug the other end of the handset cord with the long straight section
into the handset jack marked with the
+ symbol on the back of the IP
Deskphone.
3. (Optional) Thread the cord through the channel in the foot stand (if
installed) so that it exits on the side of the foot stand.
Figure4on page36 shows the connections on the back of the Avaya
1230 IP Deskphone.