Filter
Top Products
Connect the components
29
(. Plug the other end of the cable into the LAN port on the back of
your PC.
Figure 6: Cable routing tracks and mounting holes
6. Wall-mount your phone (optional). Your Avaya 1110 IP
Deskphone can be mounted either by: (Method A) using the mounting
holes on the bottom of the phone stand, or (Method B) using a
traditional-style wall-mount box with an RJ-45 connector and a 15-cm
(6-inch) RJ-45 cord (not supplied).
Complete steps 1-5, as needed, before you wall-mount your phone:
Method A: Using the stand cover (part removed in step 1), mark the
wall-mount holes by pressing the bottom of the stand cover firmly
against the wall in the location where you wish to install the phone.
Four small pins on the bottom of the stand cover make marks on the
wall. Use the marks as a guideline for installing the wall-mount
screws (not supplied). Install the screws so that they protrude 3 mm
(1/8 inch) from the wall, and then position the phone stand mounting
holes (as shown in Figure 6, Method A) over the screw heads. You
may need to remove the phone from the wall to adjust the lower
screws. When the lower screws fit snugly, tighten the top screws.
Method B: Attach the 15-cm (6-inch) CAT5e cable (not supplied),
position the phone stand mounting holes (shown in Figure 6, Method
B) over the mounting rivets, push the phone onto the mounting rivets
and down, to lock the phone into position.
Method A
Method B