Filter
Top Products
-12-
2. LE-03 (or 01-05), or dE-03 (or 01-05) will be displayed. If dE is displayed,
press the Function (F) button and LE--- (level) will be displayed.
3. Press the Up or Down button to select from 1 to 5 voice sensitivity levels,
with 1 being the most sensitive and 5 being the least sensitive.
VOX Delay Adjustment
To adjust the VOX delay:
1. Perform steps 1. through 3. above for VOX sensitivity level; then press
the Function (F) button.
2. dE-03 (or 01-05) will be displayed.
3. Press the Up or Down button to select from 1 to 5 time delays, with 1
being the fastest and 5 being the slowest.
4. Press the Monitor (M) or PTT button to exit the VOX sensitivity/delay
mode.
Roger Beep Tone
The unit will also transmit a beep tone sequence after each transmission to
signal the receiving party that transmission has ended. This tone is called a
“Roger Beep”. Press the press Function (F) button five times until the ( RGB )
icon flashes and “on” or “oF” appears. Then press Up (
) or Down ( ) button
to set the function on. The ( RGB ) icon will remain displayed. To disable the
“Roger Beep”, proceed as before, until Beep Tone icon appears flashing. Then
press Up (
) or Down ( ) buttons to set the function to off. Press the PTT
button to confirm your selection.
Button Confirmation Tone
Whenever the Up/Down or Function (F) select button is pressed, the speaker will
sound a beep tone to confirm each press, provided the key tone feature is
enabled. To disable the key tones, press Function button six times until the
Beep Tone icon (
) appears flashing and “on” or “oF” appears. Then press Up
( ) or Down ( ) to set the function off. Press the PTT button to confirm your
selection. When “oF” is selected, no beep tones should be heard. To enable
the key tones proceed as before, until Beep Tone icon appears flashing. The
“on” icon will appear. Then press Up (
) or Down ( ) button to set the function
to on and the beep tones will be heard.