Filter
Top Products
2
Telephone base and charger installation
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise
and caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
Install the telephone base as shown below.
IMPORTANT INFORMATION
Use only the power adapter supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
1.
1. Plug the small end
of the smaller power
adapter into the jack
on the underside of the
charger, then route the
cord through the slot
as shown.
2. Plug the large end
of the smaller power
adapter into a power
outlet not controlled
by a wall switch.
Charger installation
WALL
WALL
DESK
DESK
5. Plug the other end
of the telephone line
cord into a telephone
jack.
1. Plug the small
end of the larger
power adapter into
the power jack at
the bottom of the
telephone base.
3. Route cords
through slots.
4. Plug the large
end of the
larger power
adapter into a
power outlet not
controlled by a
wall switch.
Power
adapter
2. Plug one end of
the telephone
line cord into the
telephone jack at
the bottom of the
telephone base.
DSL filter (not included),
required if you have DSL high-
speed Internet service.
Telephone
line cord
Telephone
wall jack