Filter
Top Products
50
Appendix
Incomplete
messages
• If a caller leaves a very long message, part of it may be
lost when the system disconnects the call after four min-
utes.
• If the caller pauses for more than seven seconds, the
system stops recording and disconnects the call.
• If the system’s memory becomes full during a message,
the system stops recording and disconnects the call.
• If the caller's voice is very soft, the system may stop
recording and disconnects the call.
Difficulty hear-
ing messages
• Press VOLUME to increase speaker volume.
Troubleshooting
Common cure
for electronic
equipment
If the unit does not seem to be responding normally, try
putting the cordless handset in its base. If it does not seem to
respond, do the following (in the order listed):
• Disconnect the power to the telephone base.
• Disconnect the cordless handset battery, and spare battery,
if applicable.
• Wait a few minutes.
• Connect power to the telephone base.
• Re-install the battery pack, and place the cordless handset
into the telephone base.
• Wait for the cordless handset to re-establish its connection
with the telephone base. Allow up to one minute for this to
take place.
System does
not answer after
correct number
of rings
• Make sure that the answering system is on (see page 39).
• If toll saver is activated, the number of rings changes to
two when you have new messages stored (see page 35).
• If the memory is full or the system is off, the system will
answer after 10 rings.