Filter
Top Products
Getting started
Adding and registering handsets
When first purchased, all optional accessory
handsets will show NOT REGISTERED on the
screen. The new handset(s) may need to be
charged for five minutes before registering to
the telephone base.
NOT REGISTERED
PRESS HNDST LOC
4 SEC ON BASE
PLEASE WAIT...
HS X REGISTERED
To register a handset to your telephone
base
1. Make sure your handset battery is properly
installed and charged (pages 5-6).
2. Place the unregistered handset into the
telephone base. If PRESS HNDST LOC
4 SEC ON BASE does not appear on
the handset screen after a few seconds,
remove the handset and place it in the
telephone base again.
3. On the telephone base, press and hold
HANDSET LOCATOR for about four
seconds (until the red IN USE light on the
telephone base turns on) and then release
the button. The handset will show PLEASE
WAIT... and it will take about 10 seconds
to complete the registration. The handset
will show HS X REGISTERED and will beep
if the registration is successful.
NOTES:
1. If the registration is not successful, the display will
show NOT REGISTERED. To reset the handset, remove
the handset from the telephone base and place it back
in. Try the registration process again.
2. You cannot register a handset if any other system
handset is in use.
8