AT&T E5965C Telephone User Manual


 
Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the battery to charge for 12 hours before use. You can
keep the battery charged by returning the handset to the base after each use.
Place handset in base to charge
for 12 hours before first use.
Rotate antenna to fully upright
position.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
Insert supplied
batteries.
Insert top
tab first.
To replace battery cover
Press down to
click in place.
Plug power cord
transformer into
electrical outlet.
Plug long telephone
line cord into
telephone jack.
Route cords through
slot in base.
Caution: Use only the supplied
NiMH battery (80-5461-00-00) or
AT&T model 2AA NiMH replace-
ment battery (SKU 26820). Do not
use alkaline batteries.
96-5623-20-00_E5965C QSG_R1.qxd 6/29/2005 12:19 PM Page 2