AT&T EP590-3 Cordless Telephone User Manual


 
10
11
The battery
does not
charge in the
handset or
the handset
battery does
not accept
charge.
Make sure the handset is placed in the char-
ger correctly. The CHARGE light on the char-
ger should be on.
Remove the battery from the handset and
install it in the spare battery compartment
on the side of the telephone base and let
it charge for 16 hours. Then re-install the
charged battery pack into the handset.
If the cordless handset is in the charger or in
the telephone base but the CHARGE light is
not on, refer to “The charge light is off” in this
section.
It may be necessary to purchase a new bat-
tery. Please refer to the batteries section of
this user’s manual.
The telephone might be malfunctioning.
Please refer to the Warranty section of this
user’s manual for further instruction.
The CHARGE
light is off.
Clean the charging contacts on the cordless
handset(s) and telephone base each month
using a pencil eraser or a dry non-abrasive
fabric.
Make sure the power adapter and telephone
line cords are plugged in correctly and secure-
ly.
Unplug the power adapter. Wait for 15 sec-
onds before plugging it back in. Allow up to
one minute for the cordless handset and tele-
phone base to reset.
The telephone might be malfunctioning.
Please refer to the Warranty section of this
user’s manual for further instruction.
In case of difficulty