Filter
Top Products
7
Getting Started
Battery installation & charging
After battery installation, place the handsets in their base unit or charger and allow to
charge for 15 hours before use. You can keep the batteries charged by returning the
handsets to their base unit or charger after each use. When the battery is fully depleted, a
recharge takes about 12 hours. Average talk time on a fully charged battery is about eight
hours depending on environmental conditions, standby time is approximately four days.
Insert supplied
battery.
Place handset in base or charger
to charge for 15 hours before
first use.
Plug charger power
cord into jack on under-
side of charger, then
plug transformer into
electrical outlet.
Low battery indicator
Return handset to base or
charger to recharge when
this symbol flashes.
(Handset will beep when
battery is low.)
Caution: Use only supplied recharge-
able battery or AT&T replacement bat-
tery model 2420 (SKU 00578. Part
number 80-5542-00-00).
LOW BATTERY
Press tab to open
battery compartment.
Replace compartment cover.
91-000197-010-000_E5925B_R1.qxd 2/13/1950 7:21 PM Page 7