Filter
Top Products
DID YOU KNOW?
Optional spare batteries can be kept charged in
the base, for quick replacement when handset
batteries become depleted (see page47
7
Getting Started
Battery installation & charging
After installation, place the handset in the base and allow batteries to charge for 12
hours before use. You can keep batteries charged by returning the handset to the base
after each use. When battery power is fully depleted, a full recharge takes about 8 hours.
Place handset in base to charge
for 12 hours before first use.
Rotate antenna to fully upright
position
DID YOU KNOW?
Optional spare batteries can be kept charged in
the base, for quick replacement when handset
batteries become depleted (see page 42).
LOW BATTERY
REDIAL CID LOG
2:10 PM
1
Press coin into slot on
base of handset to
release latch, then
remove battery cover
Insert supplied
batteries
Low battery indicator
Return handset to base to recharge
when this symbol flashes. (Handset
will beep when battery is low.)
Caution: Use only AT&T 2AA
NiCad or NiMH rechargeable
batteries. Do not use AA
alkaline batteries.
Insert top
tab first
To replace battery cover
Press down to
click in place
ATT-5860CIB-d2.qxd 1/3/2004 11:09 AM Page 7