Filter
Top Products
50
ɇ
Troubleshooting
The answering
system does
not respond to
remote com-
mands
ƨ ƪǐǍƫƓ
ƨ ƕ Ɠ
When dialing a number, you should hear tones. If you hear
clicks, then it is not a touch-tone telephone and cannot
activate the answering system.
ƨ
code when your announcement is playing. Wait until the
announcement is over before entering the code.
ƨ
using. Press the dial pad keys firmly when dialing.
The answering
system does not
answer after the
correct number
of rings
ƨ Ɠ-
ing system is on, the red light on the ANSWER ON key
should be lit.
ƨ Ɛ
two when there are new messages waiting (page 36).
ƨ Ɛ
system will answer after ten rings. If the memory is full,
you need to delete some old messages in order to make
room for new messages.
ƨ Ɛ
the ringing system used by the local telephone company.
The answering
system does not
record message
ƨ Ɠ
ƨ
and announce “Memory full. Enter remote access code.”
You need to delete some old messages in order to make
room for new messages.
The messages
on the answer-
ing system are
incomplete
ƨ
minutes, for each message, the system will disconnect and
part of the message may be lost.
ƨ Ɛ-
tem stops recording and disconnects the call.
ƨ -
sage, the system stops recording and disconnects the call.
ƨ ƛ Ɛ
recording and disconnect the call.
The messages
on the system
are very difficult
to hear
ƨ
VOLUME on the telephone base to increase the
speaker volume.