AT&T CL82401 Telephone User Manual


 
Answering system
48
Answering system settings
Message alert tone
When the message alert tone is set to On, and there is at least one new
message, the telephone base beeps every 10 seconds. Unless you change it,
the message alert tone is set to off.
There is no audible alert at the handset.
To change the setting:
1. When the handset is in idle mode, press MENU/SELECT to enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Msg alert tone, then
press MENU/SELECT.
5. Press qCID or pDIR to choose >On or >Off.
6. Press MENU/SELECT to save the setting. You hear a
confirmation tone. Press OFF/CANCEL to cancel.
NOTES:
The message alert tone beeps only if all the conditions below are met:
- Answering system is on.
- Message alert tone setting is on.
- There are new messages.
To temporarily turn off the message alert tone, see
page 51.
Message recording time
You can set the recording time allowed for incoming
messages. The message length is three minutes by default.
To change the setting:
1. When the handset is in idle mode, press MENU/SELECT to
enter the main menu.
2. Press qCID or pDIR to scroll to >Answering sys, then
press MENU/SELECT.
3. Press qCID or pDIR to scroll to >Ans sys setup, then
press MENU/SELECT.
4. Press qCID or pDIR to scroll to >Recording time, then press MENU/SELECT.
5. Press q
CID or pDIR to choose >3 minutes, >2 minutes, or >1 minute, then
press MENU/SELECT to save the setting. You hear a confirmation tone. Press
OFF/CANCEL to cancel.
MSG ALERT TONE
>On
p
q
Remote code
>
Msg alert tone
p
q
RECORDING TIME
>3 minutes
p
q
>Recording time
Msg alert tone
p
q