Filter
Top Products
2
Telephone base installation
Install the telephone base as shown below.
The telephone base is ready for tabletop use. If you want to change to wall
mounting, read the user’s manual for details.
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
2. The power adapters are intended to be correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
1. Plug the small end
of the power adapter
into the power jack
on the bottom of the
telephone base.
2. Route the power
adapter cord
through the slot.
3. Plug one end of the
telephone line cord
into the telephone jack
on the bottom of the
telephone base.
4. Place the cords into
the channels.
6. Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
If you have
DSL high speed
Internet service,
a DSL filter (not
included) is
required.
5. Plug the other end
of the telephone line
cord into a telephone
jack or a DSL filter.
7. Raise the antenna.