Filter
Top Products
Adding and registering handsets
Register a handset to your CL84102/CL84152/CL84202/
CL84252/CL84342/CL84352 telephone base
Before you begin registration, put the
handset you wish to register near the
telephone base. Make sure the handset
shows To register, see manual.
On the telephone base, press MENU/SELECT.
On the telephone base, use qCID or pDIR to
scroll to >Settings, then press MENU/SELECT.
On the telephone base, use qCID or pDIR to
scroll to >Registration, then press
MENU/SELECT.
Press # (pound key) on the handset. Both
the handset and the telephone base show
Registering... Please wait and the IN USE
light turns on.
After a while, both the handset and the
telephone base beep and the IN USE light
turns off. Handset X Registered appears on
both the handset and the telephone base
screens (X represents the handset number).
The handset is now registered with the
telephone base.
If registration fails, the system will automatically try to register again.
If registration fails after the third try, Registration failed appears on
both screens before returning to idle mode. This may take up to five
minutes to occur. Please start again from Step 1.
NOTES:
You cannot register a handset if any other system handset is in use.
If you try to register more than 12 handsets to the telephone base, the telephone
base shows Registration slots are full and sounds 2 beeps.
1.
2.
3.
4.
5.
6.
•
•
Registration and deregistration
To register,
see manual
Registering...
Please wait
Handset X
Registered
Registering...
Please wait
Handset X
Registered
10