AT&T 9410 Cordless Telephone User Manual


 
Charging the Handset Battery Pack
This battery should remain charged up to three days with
the Ringer turned on and up to 20 days with the Ringer off.
A fully charged battery provides an average talk time of up
to five hours.
The battery pack needs charging when:
A new battery is installed in the handset.
The phone beeps four times when you press P.
The phone does not respond when you press P.
Place the handset in the base either in the face-down or
face-up position so the CHARGING light turns on. The
battery pack is typically fully charged in six hours.
You can keep the battery fully charged by returning the
handset to the base after each use.
If you repeatedly get a low battery indicator, even after
six hours of charging, the battery should be replaced.
CAUTION: To reduce the risk of fire or injury to
persons or damage to the telephone,read and
follow these instructions carefully:
Use only Replacement Battery 3300 (SKU# 90556).
Do not dispose of the battery in a fire. The cell
might explode. Check with local codes for special
disposal instructions.
Do not open or mutilate the battery. Released
electrolyte is corrosive and may cause damage to
the eyes or skin. It may be toxic if swallowed.
Exercise care in handling batteries in order not to
short the battery with conducting materials such as
rings, bracelets,and keys. The battery or conductor
may overheat and cause harm.
Charge the battery provided with or identified for
use with this product only in accordance with
the instructions and limitations specified in this
manual.
Observe proper polarity orientation between the
battery and battery charger.
Nickel-Cadmium Rechargeable Batteries
must be recycled or disposed of properly. Do
not dispose of in household garbage. If
burned, it could explode. If punctured, it
could release caustic material which could
injure the skin or eyes. If swallowed,it may be
toxic.
The RBRC
seal means that the manufacturer is voluntarily
participating in an industry program to collect and recycle
Nickel-Cadmium rechargeable batteries when taken out of
service within the United States. These batteries may be
taken to a participating local retailer of replacement batteries
or recycling center. Or,you may call 1-800-8BATTERY for
locations accepting spent Nickel-Cadmium batteries.
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the
handset by pressing on the indentation and sliding the
cover downward.
2 Lift out the old battery pack.
3 Hold the new battery pack and plug the
connector into the handset. Place the battery
pack into the case.
4 Replace the cover by sliding it on its track up over
the battery case until it snaps firmly into place.
5 The new battery pack must be charged before
using the phone. Place the handset face up or face
down in the base and allow it to charge for at least
12 hours the first charge (after that, the battery will
quick-charge in only six hours). The telephone might
operate in as little as 10 minutes,but for best
performance, let the battery pack charge fully.
5
BATTERIES
RBRC is a registered trademark of the Rechargeable Battery
Recycling Corporation.
Red wire
to left;
black wire
to right