AT&T 906 Conference Phone User Manual


 
IN CASE OF DIFFICULT Y
If this telephone does not work prop-
erly, try the following suggestions
before seeking repair assistance.
No Dial Tone
Make sure all plugs are connected
properly. Inspect the line cord con-
nections at the modular jack and at
the telephone. Also inspect the
coiled handset cord connection at
both ends.
Make sure Hold is not on.
Unplug the telephone and connect
it to another modular jack. If it
still does not work, and other tele-
phones in your home are working,
the problem is with this telephone.
Call 1 800 722-9125.
Call Cannot Be Dialed Or Is
Dialed Slowly
This product comes set in the
touch-tone mode. Make sure you
choose the correct dialing method;
touch tone dialing will not work if
you have dial pulse service.
See “Installation” to select the cor-
rect dial mode. If you have pulse
dialing service, you cannot dial
numbers with the telephone set in
the touch-tone mode.
If you just used Temporary Tone,
leave the handset on the base for
a few seconds before making
another call.
Telephone Does Not Ring
Make sure the RINGER switch is
set in the LO or HI position.
If there are several other tele-
phones on the same line, try
disconnecting some of the other
telephones. Having too many
telephones connected can also
create problems such as low ringer
volume, or impaired sound quality
during calls.
Difficulty Storing Numbers In
Memory
Review “One-Touch Dialing” and
“Speed Dialing” to make sure you
are pressing the correct sequence
of buttons.
If you are interrupted by a record-
ed announcement telling you to
hang up (or a loud buzzing noise),
hang up and try to enter the
number more quickly.
Try calling the number you want
to store into memory. When a call
is ended, press ,
and a memory button (or press
and a memory location
1-9).
If someone lifts an extension
phone while you are storing
numbers in memory, programming
might be interrupted. Make sure
all extensions are on hook while
storing numbers in memory.
You might not hear the confirma-
tion beep if the RECEIVER
(handset) volume is set too low, or
if you are in a noisy location.
If the number is more than 24
digits long, make sure you follow
the directions for “Dialing Long
Numbers.”
Speakerphone Does Not Work
The speakerphone might not work
well is someone picks up an exten-
sion phone on the same line. The
speakerphone will come back on if
the handset of the other phone is
replaced.
Other Problems
Make sure you have followed all the
instructions in this booklet. If you
continue to have problems, call
1 800 722-9125. If you cannot
correct the problem, disconnect the
telephone and refer to the warranty
information.
5