Filter
Top Products
EXIT/NORMAL (display feature)
When you are ready to leave Display or Softkey
Mode and return to Normal (call-handling) Mode
1 Press [
Exit ].
HOLD
To put a call on hold
1
Press [
Hold ].
To answer a new call while active on another
1
Press [
Hold ].
2
Press call appearance button of incoming call.
To return to held call
1
Press call appearance button of held call.
INSPECT (display feature)
To see who is calling while on a call
1
Press [
Inspect
].
●
Call source is shown on display.
2
Press [
Exit
] to return to display for present call.
LAST NUMBER DIALED
To automatically redial the last number you
dialed
1
Press [
LastDialed ]
or
Dial Last Number Dialed access code
.
LEAVE WORD CALLING (LWC)
To leave a message after dialing an extension
1
Press softkey below LWC
or
Press [
LWC
] before hanging up your handset.
6
To leave a msssage without ringing an extension
1
While off-hook press softkey below
LWC
or
Press [
LWC
]
or
Dial Leave Word Calling access code
.
2
Dial extension.
3
Hang up.
To cancel a Leave Word Calling message
1
2
While off-hook press the softkey below
CnLWC
or Press [ Cancel LWC ]
or
Dial Leave Word Calling cancel code
.
Dial extension.
PRIORITY CALLING
To place a priority call (3-burst ring)
1
While off-hook press the softkey below
PCall
or Press [ Priority ]
or
Dial Priority Calling access code
.
2
Dial extension.
RESET SPEAKERPHONE
To adjust the speakerphone to the surrounding
room acoustics
1
While on-hook, press [
Shift
] and then
press [
Speaker
].
●
You hear a series of tones.
SELECT RING (and RINGER VOLUME)
To select a personalized ring
1
2
3
Press [
Shift ] and then press [ Hold ].
●
Current ringing pattern plays, and pattern
number is displayed.
To cycle through all eight ring patterns, continue to
press (and then release) [
Hold
] (or press
[ Next> ] or [ <Prev ]).
When you hear the desired ring pattern, press
[ Shift ] again.
7
To adjust ringer volume if necessary (speaker is
not active)
1
To raise the volume, press the right half of the
Volume control button labeled [ ∧∧ ];
to lower the volume, press the left half of the
Volume control button labeled [ ∨∨ ]
SEND ALL CALLS
To send all calls (except priority calls) immediately
to coverage
1
Press [
Send Calls ]
or Dial Send All Calls access code
.
To cancel Send All Calls
1
While off-hook, press [
Send Calls ] again
or Dial Send All Calls access code
.
SPEAKERPHONE
NOTE:
To use this feature, your voice terminal must
be set for the Speakerphone (speak and listen)
feature.
To place or answer a call without lifting the
handset, or to use speakerphone with any feature
1
Press [
Speaker ].
2
Place or answer call, or access selected feature.
3
Adjust speakerphone volume if necessary:
To raise the volume, press the right half of the
Volume control button labeled [ ∧∧ ];
to lower the volume, press the left half of the
Volume control button labeled [ ∨∨ ].
To prevent the other party from hearing you
1
Press [
Mute ].
●
Red Mute light goes on.
2
Press [
Mute
] again to resume talking to party.
●
Red Mute light goes off.
8