Filter
Top Products
2
1. Set Dial Mode switch
This product comes set in
the tone (TT) mode. Make
sure you choose the
correct dialing method
(TT/DP); touch tone dialing
will not work if you have
dial pulse service.
2. Connect line cord to
telephone and wall jack
Plug one end of the line
cord into the jack on the
telephone and the other end
of the line cord into a
modular wall jack. Make
sure it snaps firmly into
place.
3. Connect handset to
telephone base
Plug one end of the coiled
handset cord into the jack
at the side of the telephone
base and plug the other end
into the handset. Then
hang up.
4. Check for dial tone
Lift the handset and listen
for a dial tone. If you can't
hear a dial tone, refer to
“In Case of Difficulty” and
try to correct the problem.
TO DISCONNECT the line
and handset cords, squeeze the
clip on the modular plug and
pull it out of the jack.
TABLE/DESK INSTALLATION
Dial Mode Switch