Filter
Top Products
Logio User’s Manual, page 21
Editing Records
To edit existing records, first navigate in “view” mode to the record you want to edit,
and then push . The cursor will blink on the first character of line 1. You can edit
the website name and/or address, user ID, and password of any record.
Navigating the cursor
Here are the ways you can navigate the cursor within a record when in “edit” or
“new” modes:
• Push or to move cursor within the current line (to move fast, push and hold
without releasing - after a slight delay the cursor will start to move fast; however,
when moving to the right, once the cursor gets to the end of the existing characters,
it will stop moving quickly so that you do not accidentally enter multiple blank spaces
at the end.)
• Push and hold and push to jump cursor to the first character of a line
• Push and hold and push to jump cursor past the last character of a line
• Push or to move cursor line by line
• Push and hold and push to jump cursor directly to line 1
• Push and hold and push to jump cursor directly to line 3
Deleting characters
Note that when you are editing a record, adding a new record, or entering your
master passcode, the Edit button already functions as a delete button and you
do not need to push it twice to invoke the delete function.
Also note that there is no “backspace” button in Logio, so to delete characters to the
left of the cursor, move the cursor to the left using the button and then push the
button.
You can delete one character at a time, or push and hold the delete button to delete
multiple characters quickly (it will start deleting multiple characters after a slight
delay).
You can also delete an entire line all at once in “edit” or “new” mode by moving the
cursor to the line you want to delete and then push and hold and push . The
screen will display:
Editing Records