Filter
Top Products
CHAPTER 4
(CONTINUED)
You may set up the DIALOGUE
RC
in the
following manner to better suit your needs.
Setting the Scan Function
If you have DIALOGUE
RC
–100:
Only the first six numbers in the memory are
automatically scanned. It stops at each mem-
ory location for 5 seconds to allow you to
select.
To turn scan function off (or on):
1. Press PROGRAM.
2. Press 0 on the keypad to turn it off;
or press 1 key on the keypad to turn it on.
3. Press SCAN button.
If you have DIALOGUE
RC
–200:
All memory locations with numbers stored are
automatically scanned. The scan rate deter-
mines how long the DIALOGUE
RC
–200
pauses at each memory location before mov-
ing on to the next one.
To turn scan function on or off:
1. Press
PROGRAM.
VOL
PROG SCAN
MU
T
HEA
D
MIC
Key Entered
Length of Pause at Each
Location in Seconds
Scan Function Off
5
4.5
4
3.5
3
2.5
2
1.5
1
Figure 7
5
Figure 6
2. Using chart, select length of pause
and press the corresponding digit on
keypad.
To turn V
oice Activation on (or off)
(RC–200 only):
1. Press PROGRAM.
2. Press MUTE button twice. The MUTE
indicator flashes once, and the RC-
200 emits four beeps to confirm that
Voice Activation has been turned on.
3. To turn it off, repeat steps 1 and 2.
This command is confirmed by four
beeps.
To turn the Unanswered Call Indicator
(RC-200) feature off (or on):
1. Press PROGRAM.
2. Press HEADSET button twice.
(Emits four beeps to confirm command).
3. To turn it on again, repeat steps 1
and 2, and the HEADSET indicator
flashes once.
T
o turn the Voice Mail Indicator feature
on (or off), (RC–200 only):
1. Press PROGRAM.
2. Press FLASH/PAUSE button twice.
RC–200 emits four beeps and the
FLASH/PAUSE indicator flashes
once.
3. To turn it off again, repeat steps 1
and 2, and the FLASH/PAUSE
indicator does not flash.
To turn the Remote Flash feature on (or
off) (RC–200 only):
1. Slide remote flash switch to "On" (or
"Off") position.
3. Press SCAN
button.
Figure 8
VOL
PROG
SCAN
MUTE
HEADSET
MIC