Filter
Top Products
8
Installation
Follow the steps below to connect
and install your PHOTO PHONE.
A. Desk Mounting
1. Set the dial mode switch to T
(tone) if you have touch tone
service. Set the switch to P
(pulse) if you have pulse
(rotary) dialing.
2. Connect telephone line cord
to telephone as shown in
figure 3.
3. Connect handset cord to the
telephone as shown in figure 3.
4. Lift the handset and listen for
a dial tone.
5. Your
PHOTO PHONE
is
ready to use.
B. Wall Mounting
1. Pull the handset hook out and
reverse its position so that the
hook points up and will hold
the handset when you hang
up as shown in figure 4.
2. Insert the tabs of the phone
base into the slots in the lower
position of the base. Push in
and down firmly until it snaps
into place as shown in figure 5.
Figure 3 -Connections and installation
$$
Figure 4 - Handset hook change
1
4
1
4