Filter
Top Products
Installation
803447
8
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
Connecting Hoses
Insert each filter screen into the end of each fill hose
that will connect to the water supply faucet. The screen
must be facing outward. Refer to Figure 4.
Insert each plain rubber washer into the other end of
each fill hose that will connect to the water mixing
valve at the rear of the washer. Refer to Figure 4.
For hoses with metric couplings, connect black hose
coupling to water supply faucet. Connect brass hose
coupling to water mixing valve connection at rear of
washer.
Thread hose couplings onto valve connections finger-
tight, then approximately 1/4 turn with pliers.
IMPORTANT: DO NOT cross thread or
overtighten couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
Figure 4
IMPORTANT: Hoses and other natural rubber
parts deteriorate after extended use. Hoses may
develop cracks, blisters or material wear from the
temperature and constant high pressure they are
subjected to.
All hoses should be checked on a monthly basis for
any visible signs of deterioration. Any hose showing
the signs of deterioration listed above should be
replaced immediately. All hoses should be replaced
every five years.
Figure 5
IMPORTANT: Turn off water supply faucets after
check-out and demonstration. Owner should turn
off water supply whenever there will be an
extended period of non-use.
NOTE: Longer fill hoses are available (as optional
equipment at extra cost) if the hoses supplied with
the washer are not long enough for the installation.
Order hoses as follows:
No. 37380 Fill Hose 2.44 m (8 feet - 1 standard, 1
metric hose coupling)
No. 37381 Fill Hose 3.05 m (10 feet - 1 standard, 1
metric hose coupling)
No. 20617 Fill Hose 2.44 m (8 feet - 2 standard hose
couplings)
No. 20618 Fill Hose 3.05 m (10 feet - 2 standard
hose couplings)
TLW1976N
1 Faucet
2 Fill Hoses
3 Plain Rubber Washer
4 Install this end of hose to valve connections
at rear of washer
5 Install this end of hose to water supply faucet
(Black colored coupling for metric)
6 Filter Screens
HOT
COLD
2
1
3
6
5
4
FLW1981N
1 Water Supply Faucets
2 Hot Water Connection
3 Cold Water Connection
4 Fill Hoses
FLW1981N
2
1
3
4
WATER
MIXING
VALVE