Filter
Top Products
Troubleshooting
Dialog 4223 Professional/Dialog 4225 Vision132
Troubleshooting
If your phone is out of order, you can initiate a telephone self-test to
check whether there is a fault in the phone or in the system. You
can also separately check the firmware revision state of your
phone.
To initiate a telephone self-test
Dialog 4223 Professional:
PhoneSet Press (see display).
If
PhoneSet is not shown, press more... until it appears.
Select Press (see display).
Down or Up Press to frame Local Test Mode (see display).
Select Press (see display).
The display shows the firmware revision state and
Selftest OK
for a few seconds. If there is something wrong, a fault message
appears. Inform your system administrator about the fault
message.
All the key lamps on the phone and connected extra key panels
should be switched on during the self-test to indicate that each key
lamp is OK.
After a few seconds the display is checked (the display is
completely dark). The display is OK when there are no light dot(s) or
line(s). The light frame around the display should be there.
Exit Press the left most display Menu key to exit (see display).
(However the text is not visible when the display has turned black,
the exit feature is still on that Menu key).
Note: If you do not press
Exit, the self-test is automatically
finished after about 30 seconds.