Filter
Top Products
2
Install the telephone base and charger as shown below. If you subscribe
to high-speed Internet service (DSL - digital subscriber line) through your
telephone line, you must install a DSL filter between the telephone line cord
and the telephone wall jack. The filter prevents noise and caller ID problems
caused by DSL interference. Please contact your DSL service provider for
more information about DSL filters.
The telephone base comes ready for tabletop use. If you want to mount
your telephone on a wall, refer to Wall mount installation in the user’s
manual for details.
Telephone base and charger installation
IMPORTANT INFORMATION:
Use only the power adapters provided with
this product. To obtain a replacement, visit our
website at www.telephones.att.com
or call 1 (800) 222-3111. In Canada,
dial 1 (866) 288-4268.
The power adapters are intended to be
correctly oriented in a vertical or floor mount
position. The prongs are not designed to hold
the plug in place if they are plugged into a
ceiling or an under-the-table or cabinet outlet.
•
•
Raise the antenna.
Plug the large end
of the smaller power
adapter into an
electrical outlet not
controlled by a
wall switch.
Ensure the small end
of the smaller power
adapter is plugged into
the power jack on the
back of the charger.
Route the cord through
the slot.
Telephone line cord
A DSL filter (not included)
is required if you have
DSL high-speed Internet
service.
Telephone wall jack
Electrical outlet not
controlled by a wall
switch
Plug the small end
of the larger power
adapter into the power
jack on the back of the
telephone base.
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
Plug one end of the
telephone line cord
into the TEL. LINE jack
on the back of the
telephone base.
Plug the other end of
the telephone line cord
into a telephone wall
jack.
Route the cords
through the slot.