Filter
Top Products
3
Getting started
Telephone base & charger installation
Install the telephone base as shown below. Make sure that the electrical outlet
is not controlled by a wall switch.
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter will prevent noise and
caller ID problems caused by DSL interference. Please contact your DSL service
provider for more information about DSL filters.
The telephone base comes with the mounting bracket installed for desktop use.
Also, the telephone line cord and the power adapter are already plugged into
the telephone base. If you want to change to wall mounting installation, see the
Mounting bracket procedure section in the user's manual for details.
Telephone base installation
1. Plug the other end
of the telephone line
cord into a telephone
jack.
2. Plug the power
adapter into an outlet
not controlled by a
wall switch.
Power
adapter
DSL filter (not included),
required if you have
DSL high-speed Internet
service.
Telephone
line cord
3. Make sure the
telephone line cord
and power adapter
cord are routed
through the slots on
the bracket.
4. Raise the antenna.