Filter
Top Products
Programming the System
3M Model D-2400
8
Programming the Selector
Programming State
1
2
3
4
5 6
7
8 9
0
MENU
T
A
L
K
SP-389C
Figure 5. D-2400 Keypad
To program the D-2400, it is necessary to put the system in the
programming state. From this state, the entire system is configured
and all memorized parameters are adjusted.
To enter the programming state, simultaneously:
Press and hold the STD BY key.
Enter the numeric code: 97531.
The display shows:
The Parameter #, Parameter Name/Value, and Parameter Value
fields are as shown below.
Parameter
Parameter # Name/Value
↓ ↓↓
↑↑
Parameter Value
The _ indicates cursor position. To move the cursor from one field
to another, use the Left Arrow and Right Arrow keys.
To input data at the cursor position, do one of the following:
• Use the Up Arrow and Down Arrow keys to scroll to
desired value.
• Use the 1, 2, 3, 4, 5, 6, 7, 8, 9, 0/Menu keys.
The STD BY key clears a field to a default value (space for text or
the default value).
The HOLD key shifts case for text data.
The ALL CALL key exits from the programming state and enters
the Off Line mode.
!
Important
All Selectors ship from the factory with a default ID number of 15. It is important to connect
and power up each new selector, ONE SELECTOR AT A TIME, when installing a new
system. Doing this allows you to change the ID number to a lower value (start at 1) and avoid
the erratic behavior caused by multiple selectors sharing the same ID number.
01:Selector ID #
{01}
01:Selector ID #
{01}