Filter
Top Products
Copyright©2003 Nokia. All rights reserved.
Getting started
6
Note: Keep all miniature SIM cards out of the reach of small children.
Note: If you want to configure the Nokia Observation Camera settings with SMS messages,
disable the PIN code request on your SIM card before inserting it into the camera. If the PIN
code request is active, you can only configure the camera settings with PC Suite.
2. If you configure the camera settings with PC Suite, connect the serial data cable to the data
connector at the back of the camera and to the COM port of a compatible PC.
3. Attach the power source to the power connector of the camera and plug it into a mains outlet. If
the LEDs on the camera light up, the camera receives power from the mains outlet.
4. Configure the camera settings either with PC Suite or with SMS commands, see Configuring the
settings with PC Suite on page 9 and Configuring the settings with SMS on page 18.
5. After completing the configuration, disconnect the serial data cable, and power off the camera by
unplugging it from the mains outlet.
6. Attach the camera to the desktop stand with the screw, turn the stand to the usage position and
tighten the screw with the tool included in the sales package. To tighten the ball joint, remove the
rubber shield and tighten the screw. See Figure 4.