Filter
Top Products
PIB # 351305
Page 2 of 2
Pioneer New Media Technologies, Inc., Engineering Support (310) 952-2111
To return the PDP-502MX plasma display to the default settings, follow the instructions below. This
series of commands affects only the
Picture
settings.
1) Set the PDP-502MX to the Standby mode.
2) Wait until the small red light on the side of the panel stops blinking before proceeding.
3) Press and release
Menu
on the remote control.
4) Within three seconds, press
Standby
on the remote control.
It may take up to ten seconds for the Integrator Menu to appear. The word,
Picture
, is
highlighted in pink on this menu.
5) Press the Right Arrow button on the remote control once.
6) Press the Up Arrow button on the remote control to highlight the word,
Default
.
7) Press
SET
on the remote control.
8) Press the Left Arrow button on the remote control to confirm the default setting.
9) Press
SET
again to confirm the change and return to the previous menu.
10) Press
Menu
on the remote control to exit the Integrator Menu.
Standby button
Menu button
Set button
Arrow buttons
For additional assistance please contact your Pioneer representative or refer to the website:
www.pioneer-america.com