Filter
Top Products
support.dell.com Dell PowerApp 100 Appliances Rack Installation Guide 13
Recommended Tools and Supplies
You need the following tools and supplies to install the system in a four-post rack
cabinet:
• A #2 Phillips screwdriver
• A flat-blade screwdriver
• An installation template, helpful in slide assembly placement and alignment
• Masking tape or a felt-tip pen, for use in marking the mounting holes to be used
Installing the Rack Kit
NOTES: If you purchased a Dell rack along with your PowerApp system, the slide
assemblies may be preinstalled in the rack.
For instructions on installing the PowerApp system itself, see “Installing the System
in the Rack” found later in this guide.
To install the slide assemblies in the rack, perform the following steps:
1. Remove the rack’s front and back doors.
2. Install the slide assemblies in the rack.
The subsections that follow include instructions for performing these tasks.
Removing the Doors From the 42-U Rack
CAUTION: To prevent personal injury due to the size and weight of the
doors, never attempt to remove the doors by yourself.
CAUTION: Store the two doors where they will not injure someone if the
doors accidently fall over.
1. Open the latch on the front door (see Figure10).
Slide the button cover up as far as it will go, press the push button, rotate the
handle clockwise until the latch releases, and then pull the door open.