VTech i6775 Cordless Telephone User Manual


  Open as PDF
of 1
 
STEP 1 Check package contents
Make sure your phone’s packaging includes the following:
STEP 3 Battery installation
1. Align the two holes in the plug with the socket pins,
then snap the plug into place. Place the battery in the
compartment with the wires in the upper right corner.
2. Replace cover by sliding it upwards until it clicks into
place.
STEP 4 Charge the battery
1. Place the handset in the base unit/chargers.
2. Chargethebatteryforatleast16hoursbeforerstuse.
Quick Start Guide
i6775
STEP 2 Connect power to telephone base/
chargers
Plug the power adaptor into an electrical outlet not controlled
by a wall switch, and the connector into the power jack on
bottom of the telephone base/chargers.
NOTE:
• Use only the power adaptors supplied with your
VTech telephone.
STEP 5 Connect to phone line
Plug one end of the telephone line cord into the telephone line
jack at the bottom of the telephone base. Then plug the other
end of the cord into the wall telephone outlet.
Step 7 Set the clock
1. Press TIME/SET to listen to the current setting.
2. Press TIME/SET again to indicate changes needed.
3. Press CHANGE to change the day, hour, minute, or year.
4. When you hear the correct setting, press TIME/SET to
advance to the next setting.
Step 8 Record your outgoing announcement
1. Press SETUP, the system announces “Announcement.
Press PLAY or press RECORD. To continue setup, press
SETUP.”
2. Press REC/MEMO and speak toward the MIC on the base
to record an announcement for up to 90 seconds.
3. Press PLAY/STOP /
(whennishedrecording).
Hanging up
Press OFF or place
the handset in its
base/chargers.
IMPORTANT!
If your product is not working properly:
1. Refer to your user’s manual.
2. Visit our website at www.vtechphones.com or
www. vtechcanada.com in Canada.
3. Call our customer service at 1-800-595-9511 or
1-800-267 7377 in Canada.
NOTE:
If you have caller ID service, the time will automatically
beupdatedwiththerstincomingcallafteryour
program the year into the system.
NOTE:
For complete feature instructions, please refer to your
user’s manual.
AC power outlet
AC power outlet
Telephone outlet
STEP 6 Making and receiving calls
Making a call
• Press TALK/FLASH or SPEAKER and listen for dial
tone.
• Dial the phone number.
-OR-
• Dial the phone number.
• Press TALK/FLASH.
Receiving a call
Press TALK/FLASH, SPEAKERPHONE, or any dialing key
except OFF.
96-006097-010-000
issue 0
Base unit
Handsets(3)
Telephone
line cord
Batteries(3)
Beltclips(3)
Wall mount
bracket
Base power adaptor
Chargerpoweradaptors(2)
User’s manual
Chargers(2)
Quick start
guide