Filter
Top Products
I
1-
Mobile Installation
Plan the location ofthe radioand microphone bracket before starting installation.
Select a location that isconvenient for operation and does not interfere with the
driveror passenger in the vehicle. The radio should be securely fastened to a solid
surface using the mounting bracket and self-tapping screws which are provided.
MOBILE ANTENNA
Since the maximum allowable power output of the transceiver is limited by the DOT AC, theantenna
is a very important factor affecting transmission distance. It is for this reason that we strongly
recommend that you install only a quality antenna in your new CB radio system. You have
purchased a superior quality transceiver.. Don't diminish its performance by installing an inferior
antenna.
Only a properly matched antenna system will allow maximum power transfer from the SO-ohm
transmission line to the radiating element. We recommend that you use a SWR meter when
installing your antenna. Set your PRO 640XL to channel 20 and make adjustments to the antenna
until the meter shows SWR = 1. Your local dealer is qualified to assist you in the selection of the
proper antenna to meet your application requirements.
For automobile installation, the whip antenna may be used with good effect. The most efficient and
practical installation is a full quarter wave whip antenna mounted on the rear deck or fender top,
midway between the rear window and bumper.
A short "loaded" whip antenna is more convenient to install on your automobile, although the
efficiency is less than a fullquarter wavewhip antenna.
For marine installation, consult your dealer for information regarding an adequate grounding
systemand preventionof electrolysis between fittings on the hull and water.
GROUND INFORMA nON
Most newer cars and small trucks use a negative ground system, while some older
cars and some newer, larger trucks may use a positive ground system. A negative
ground system isgenerally identified bythe "-" battery terminal being connected to
the vehicle motor block, but ifyou cannot determine the polarity of your vehicle,
consult your vehicle dealer for information.
NOTE: This radio may be installed and used in any 12-volt DC negative
or positive ground system.
NEGATIVE GROUND SYSTEM
Ifyou are operating on a negative ground system, connect the red DCpower cord
from the radio to the positive "+" battery terminal or other convenient point and
connect the black power lead to the chassis or vehicle frame, or the negative "-"
terminal of the battery.
POSITIVE GROUND SYSTEM
Ifyou are operating on a positive ground system, connect the black DC power
cord from the radioto the negative "-" battery terminal or other convenient point
and connect the red power lead to the chassis orvehicle frame, or the positive "+"
terminal of the battery.
..1:
~
- -
=[--