Uniden MHS75 Two-Way Radio User Manual


 
E-17
Uniden MHS75 Radio Owner’s Manual
Setting the UIC channel mode
The radio comes preset to use the channels assigned for
the US. If your current area uses Canadian or international
channel assignments, press the UIC-Lock key to rotate
through the US, Canadian, and international channels.
Maintenance and Troubleshooting
Due to its rugged design, the MHS75 requires very little
maintenance. However, it is a precision electronic instrument,
so you should follow a few precautions:
If the antenna has been damaged, do not transmit except
in an emergency situation. Transmitting with a defective
antenna may cause further radio damage.
You are responsible for continued FCC technical
compliance of your radio.
You should arrange for periodic performance checks with
your Uniden dealer.
Common questions
Problem Things to Try
The radio won’t turn on. Charge the battery.
The power LED on the
charger doesn’t turn on.
Replace the fuse inside the charger. (Contact
customer service for a replacement fuse and
instructions on changing it.
Replace the battery.
The radio won’t
transmit.
Make sure you are not in weather or scan
mode.
Make sure you are not trying to transmit on a
receive-only channel or transmit at the wrong
power level for this channel (see the channel
lists starting on page 19).
Check the battery power level; if it’s low,
charge the battery before trying to transmit.
Make sure the duration of each transmission
is less than 5 minutes.