Uniden FRS500 Two-Way Radio User Manual


 
9
Scan Mode
Your radio also allows you to scan for activity from other transmitting radios regardless of
the channel and code setting.
Make sure all of your CTCSS codes are set to “0” prior to scanning. Otherwise, during a
scan cycle, your radio will only check for that specific channel and code combination.
To use the Scan feature:
1. Press the scan button to begin scanning
channels. The LCD will indicate that you
are in scan mode.
If a signal is present, the radio will stop
on the active channel. It will remain on
the channel until the transmission ends.
After 2 seconds, it will resume scanning.
2. To resume scanning prior to the transmission end, press scan again.
3. Press the scan, call, PTT, up, or down button to exit the scan mode, stopping at the
current channel.
If pressing scan to exit the scan mode, the radio must be actively
scanning.
FRS500(166x125).qxd 7/25/00 18:20 Page 9