Filter
Top Products
13
RF exposure information
This product complies with FCC radia on exposure limits under
the following condi ons:
• The base must be placed to allow a minimum of 20 cm (8 inches) between
the antenna and all persons during normal opera on.
• The base must not be collocated or operated in conjunc on with any other
antenna or transmi er.
The handset is designed for body-worn opera on and meets FCC
RF exposure guidelines when used with any belt clip, carrying
case, or other accessory supplied with this product. (All necessary
accessories are included in the package; any addi onal or op onal
accessories are not required for compliance with the guidelines.)
Third party accessories (unless approved by the manufacturer)
should be avoided as these might not comply with FCC RF
exposure guidelines.
Industry Canada (I.C.) Notice
Terminal equipment
NOTICE: This equipment meets the applicable Industry Canada
Terminal Equipment Technical Specifi ca ons. This is confi rmed
by the registra on number. The abbrevia on
IC
before the
registra on number signifi es that registra on was performed
based on a Declara on of Conformity indica ng that Industry
Canada technical specifi ca ons were met. It does not imply that
Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal
equipment is marked on the equipment itself. The REN assigned to
each terminal equipment provides an indica on of the maximum
number of terminals allowed to be connected to a telephone
interface. The termina on on an interface may consist of any
combina on of devices subject only to the requirement that the
sum of the Ringer Equivalence Numbers of all the devices does not
exceed 5.