Filter
Top Products
INSTALLING YOUR TELEPHONE
Included with the BTX series phones are (one each:)
• Line cord • Coiled handset cord
• Handset • User guide
• Clear plastic overlay
Contact your supplier or Teledex for information on
custom-designed faceplates that will greatly enhance the
appearance of your telephone.
1) Located on the left side of the phone is a modular jack
labeled TO HANDSET. Insert one end of the coiled hand-
set cord into this jack (you will hear the cord plug click
when it is properly and securely inserted).
2) Insert the plug on the other end of the coiled handset
cord into the modular jack on the handset.
3) Turn the telephone so the back panel is facing you.
Insert either end of the line cord into the jack on the back
of the telephone labeled TO TEL.
4) Insert the other end of the line cord into a
telephone wall outlet jack.
5) Once your telephone is connected, place a paper
faceplate over the keys. The plastic overlay slips into place
by hooking the tabs on the overlay into the recessed slots
located on both sides.
(Hint: the overlay is easiest to insert when the left or right
side tabs are inserted first, and the middle part of the over-
lay is slightly bent to allow for insertion of the other tabs.)
PLACING A CALL ON THE HANDSET
1) Lift the handset.
2) Listen for dial tone, dial the desired number, or press an
AUTO DIAL key to automatically dial a number.
3) To end the call, hang up by replacing the
handset in the cradle.
RECEIVING A CALL ON THE HANDSET
1) Lift the handset to connect to the ringing line.
2) To end the call, hang up by replacing the
handset in the cradle.
AUTO DIAL/ONE TOUCH FEATURE KEYS
The BTX series has programmable AUTO DIAL keys.
(Depending on the model purchased, your phone may
either five or ten auto dial keys.)These keys can be
programmed to automatically dial telephone numbers
or activate telephone system features.
The phone will dial the stored number each time an AUTO
DIAL key is pressed.
Some of the AUTO DIAL locations may have been
pre-programmed before installation.
STORING AUTO DIAL/ONE TOUCH KEYS
To store an AUTO DIAL number:
The phone must be connected to a telephone line.
1) Lift the handset.
2) Press the STORE key (see diagram on reverse) and
release it.
3) Enter the telephone number including PAUSE
or FLASH as required (see diagram on reverse).
The dialing sequence can be up to fifteen (15)
digits long.
4) Press the AUTO DIAL key where the number is to be
stored.
5) Replace the handset.
USING THE HOLD KEY
To place a call on hold:
1. Press the red HOLD key. The red HOLD LED will
light. The handset can be replaced without disconnecting
the call.
2. To return to the call on HOLD, remove the handset from
the cradle, or press the HOLD key.
HANDSET VOLUME KEY
The HANDSET VOLUME key will increase the handset
volume. Pressing this button during a call will increase the
receive volume. Pressing again will return the volume to
the normal level. The handset volume is reset to normal
with each new call.
USERS GUIDE
BTX4530 & BTX4535 Series Telephones