Filter
Top Products
Basics
16
US
Do this
Set the VOL switch to H (high), M (middle) or L
(low).
Press (*TONE) after you’re connected.
The line will remain in tone dialing until
disconnected.
To
Adjust the handset volume
Switch to tone dialing
temporarily
1 Pick up the handset from the
base unit.
2 Press (TALK) and wait until
“TALK” appears on the display.
The display also shows the
operation duration in hours,
minutes and seconds.
The dialing keys light up for
five seconds.
You will then hear a dial tone.
The LINE lamp on the base unit
lights up.
If “CHANNEL SEARCHING”
appears on the display, move
closer to the base unit.
3 Dial the phone number.
4 When you’re done talking, press
(OFF) or replace the handset on
the base unit.
The display and the LINE lamp
on the base unit go off.
Basics
Making calls
Additional tasks
(REDIAL)
(*TONE)
VOL switch
Notes
• When you increase the sound volume, in some cases the back ground noise
may be increased as well. You should adjust the volume accordingly.
• If your conversation is muted and “CHANNEL SEARCHING” appears on
the display, move closer to the base unit; otherwise, the call will be
disconnected after one minute.