Silicon Laboratories C8051F341 Two-Way Radio User Manual


 
C8051F340/1/2/3/4/5/6/7
142 Rev. 0.5
14.4. 4x Clock Multiplier
The 4x Clock Multiplier allows a 12 MHz oscillator to generate the 48 MHz clock required for Full Speed
USB communication (see
Section “16.4. USB Clock Configuration” on page 170). A divided version of
the Multiplier output can also be used as the system clock. See Section 14.5 for details on system clock
and USB clock source selection.
The 4x Clock Multiplier is configured via the CLKMUL register. The procedure for configuring and enabling
the 4x Clock Multiplier is as follows:
1. Reset the Multiplier by writing 0x00 to register CLKMUL.
2. Select the Multiplier input source via the MULSEL bits.
3. Enable the Multiplier with the MULEN bit (CLKMUL | = 0x80).
4. Delay for >5 µs.
5. Initialize the Multiplier with the MULINIT bit (CLKMUL | = 0xC0).
6. Poll for MULRDY => ‘1’.
Important Note: When using an external oscillator as the input to the 4x Clock Multiplier, the exter-
nal source must be enabled and stable before the Multiplier is initialized. See Section 14.5 for
details on selecting an external oscillator source.
SFR Definition 14.5. CLKMUL: Clock Multiplier Control
Bit7: MULEN: Clock Multiplier Enable
0: Clock Multiplier disabled.
1: Clock Multiplier enabled.
Bit6: MULINIT: Clock Multiplier Initialize
This bit should be a ‘0’ when the Clock Multiplier is enabled. Once enabled, writing a ‘1’ to
this bit will initialize the Clock Multiplier. The MULRDY bit reads ‘1’ when the Clock Multiplier
is stabilized.
Bit5: MULRDY: Clock Multiplier Ready
This read-only bit indicates the status of the Clock Multiplier.
0: Clock Multiplier not ready.
1: Clock Multiplier ready (locked).
Bits4–2: Unused. Read = 000b; Write = don’t care.
Bits1–0: MULSEL: Clock Multiplier Input Select
These bits select the clock supplied to the Clock Multiplier.
R/W R/W R R/W R/W R/W R/W R/W Reset Value
MULEN MULINIT MULRDY - - - MULSEL 00000000
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0 SFR Address
0xB9
MULSEL Selected Clock
00 Internal Oscillator
01 External Oscillator
10 External Oscillator / 2
11 RESERVED