Filter
Top Products
C8051F340/1/2/3/4/5/6/7
106 Rev. 0.5
SFR Definition 11.2. RSTSRC: Reset Source
Bit7: USBRSF: USB Reset Flag
0:
Read: Last reset was not a USB reset; Write: USB resets disabled.
1:
Read: Last reset was a USB reset; Write: USB resets enabled.
Bit6: FERROR: Flash Error Indicator.
0: Source of last reset was not a Flash read/write/erase error.
1: Source of last reset was a Flash read/write/erase error.
Bit5: C0RSEF: Comparator0 Reset Enable and Flag.
0:
Read: Source of last reset was not Comparator0; Write: Comparator0 is not a reset
source.
1:
Read: Source of last reset was Comparator0; Write: Comparator0 is a reset source
(active-low).
Bit4: SWRSF: Software Reset Force and Flag.
0:
Read: Source of last reset was not a write to the SWRSF bit; Write: No Effect.
1:
Read: Source of last was a write to the SWRSF bit; Write: Forces a system reset.
Bit3: WDTRSF: Watchdog Timer Reset Flag.
0: Source of last reset was not a WDT timeout.
1: Source of last reset was a WDT timeout.
Bit2: MCDRSF: Missing Clock Detector Flag.
0:
Read: Source of last reset was not a Missing Clock Detector timeout; Write: Missing
Clock Detector disabled.
1:
Read: Source of last reset was a Missing Clock Detector timeout; Write: Missing Clock
Detector enabled; triggers a reset if a missing clock condition is detected.
Bit1: PORSF: Power-On / V
DD
Monitor Reset Flag.
This bit is set anytime a power-on reset occurs. Writing this bit selects/deselects the V
DD
monitor as a reset source.
Note: writing ‘1’ to this bit before the V
DD
monitor is enabled
and stabilized can cause a system reset.
See register VDM0CN (SFR Definition 11.1).
0:
Read: Last reset was not a power-on or V
DD
monitor reset; Write: V
DD
monitor is not a
reset source.
1:
Read: Last reset was a power-on or V
DD
monitor reset; all other reset flags indeterminate;
Write: V
DD
monitor is a reset source.
Bit0: PINRSF: HW Pin Reset Flag.
0: Source of last reset was not /RST pin.
1: Source of last reset was /RST pin.
Note: For bits that act as both reset source enables (on a write) and reset indicator flags (on a
read), read-modify-write instructions read and modify the source enable only. This applies to
bits: USBRSF, C0RSEF, SWRSF, MCDRSF, PORSF.
R/W R R/W R/W R R/W R/W R Reset Value
USBRSF FERROR C0RSEF SWRSF WDTRSF MCDRSF PORSF PINRSF Variable
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0 SFR Address:
0xEF