■ Parts supplied with remote controller
See Table 1.
■ Remote controller installation guidelines
• Mount the remote controller 1 to 1.5 meters off the
floor where it can sense the average temperature of
the room.
• Do not mount the remote controller in a place
exposed to direct sunlight or where it is exposed to
outside air such as near a window.
• Do not mount the remote controller behind a curtain
or other object so that it is separated from the air cir-
culation of the room.
• Mount the remote controller inside the room being air
conditioned.
• The remote controller should be mounted on a wall or
other surface vertically.
Room temperature sensors are separately incorporated
in both the indoor unit and the remote controller. Either
sensor can be used to sense the room temperature. The
indoor unit sensor is usually used.
If you wish the remote controller to sense the room tem-
perature, press the SENSOR button with a ballpoint pen
or tool with a small tip.
■ How to install the remote controller
<NOTE 1> Do not twist the remote controller wire
with the power cord, or run them in the
same metal conduit, because this may
cause a malfunction.
<NOTE 2> Install the remote controller away from all
sources of electrical noise.
<NOTE 3> Install a noise filter or take other appro-
priate action if electrical noise affects the
power supply circuit of the unit.
• Use an electric junction box (supplied locally) for
embedded mounting of the remote controller.
(See Fig. 1)
Switching the room temperature sensor
Installation location
