Filter
Top Products
4
PREPARATION
CHECK THE CONTENTS OF THE BOX
Check if the product package box includes all the components as follows:
• Phone body including a base
• Handset and Handset Cord
• Patch cable
NOTE: Power transformer sold separately.If any of these items are missing or dam-
aged, please contact your dealer.
PHONE INSTALLATION
Connecting the Phone Body
1
Remove the base of the phone by
pressing the [Push] mark on the top
of the base.
2
Connect a handset to the handset port
of the phone.
Connect RJ45 cable through middle
hole of stand to LAN and the other
end of cable to the phone system
(data network). If PoE data switch is
used,it will power up the phone.
3
OPTIONAL:Connect the cable
through the middle hole of the base
to the PC,as shown in the figure.
When connecting to PC,connect one
end of the cable to the PC port of the
phone,and the other end of the cable
to the LAN port of the PC.
q
w
e
qAC Power wLAN to Phone System ePhone to PC-10/100 Base T Switch
smt-i3105_combined_user_guide.qxp 4/26/2010 2:08 PM Page 4
5
Connect the LAN cable (connected through the middle hole of the base to a
network) to the LAN port of the phone,as shown in the figure.
When power is supplied from the LAN port (PoE) (802.3af),the phone is
powered via LAN connection.
If PoE is not supported,connect the power adapter to the power (-DV 5V)
port of the phone by running the cable through the middle hole of the base
as shown in the figure below.If the connected power adapter is plugged into
an outlet (120AC),the phone is booted.(The power adapter is supplied
separately.)
4
Fix the base to the phone body by fit-
ting the bottom groove and then
securing the top side.
5
Secure the cable along the cable
guideline as shown in the figure.For
the cable of power adaptor, give
some slack before securing the cable
to the guideline to prevent easy
disconnect.
Data Switch
m m
(
5.0VDC
3 Amps
smt-i3105_combined_user_guide.qxp 4/26/2010 2:09 PM Page 5