Filter
Top Products
Guide No.: GH68-12459A
09/2006. Rev. 1.0
Quick Start Guide
Samsung
Bluetooth
®
Headset
WEP180
Thank you for purchasing the Samsung Bluetooth
Mono Headset WEP180, we hope you will be
delighted with its operation.
Take a moment before you get started to
familiarize yourself with your new headset.
Make sure you have the following items with your
headset:
Make sure you have the following items with your
headset:
Travel adapter, User’s Guide, 1 ear hookTravel adapter, User’s Guide, 1 ear hook
Check the accessoriesCheck the accessories
Charge your headsetCharge your headset
Charge the headset's battery fully before using
the headset for the first time.
1
Plug the travel adapter into the jack on the
headset.
2
Plug the travel adapter into the electrical
outlet.
3
Remove the travel adapter from the headset.
• Charge the headset until the red light on the
headset turns to blue.
• The headset will be fully charged in
approximately 2 hours 30 minutes.
Before you can use your headset, you must pair it
with your phone.
Put your headset in
pairing mode
Turn on Bluetooth on your
phone and pair with headset
Your phone and headset are now paired and
ready to make and receive calls. To confirm
they are operating properly, make a call:
1
Place the headset over your ear.
See Wearing the headset on the reverse
side of this guide.
2
On your phone, make a call to the number
you want.
3
If your phone and headset are successfully
paired, you will hear ringing on the headset.
After you have successfully paired your phone
and headset, you do not need to repeat these
initial setup steps each time you use the
headset.
Test and use
Using your WEP180
See Features and Functions Guide
on the reverse side of this guide
for information on using your
WEP180.
1
Ensure that the headset is off (see Turn
headset on/off on the reverse side of this guide).
2
Press and hold the Multi-Function button until
the indicator light turns on in blue
(approximately 8 seconds).
Before using your headset
Multi-Function
button
Earpiece
Volume control
buttons
Indicator light
Adapter jack
Microphone
NOTES:
• The headset cannot be used while charging.
• Use only a Samsung-approved charger or adapter.
Start here
Charge your headset
Put your headset in pairing mode
Turn on Bluetooth on your phone and
pair with headset
Test and use
Get connected in 4 quick steps
Headquarters:
1301 East Lookout Drive Suite 150
Richardson, TX 75082
Internet Address:
http://www.samsungmobileusa.com/
accessories
Customer Care Center:
1-888-987-4357
NOTE:
The items supplied with your headset and the accessories
at your Samsung dealer may vary, depending on you
country or service provider.
• Bluetooth version: 2.0 (compatible with devices of
Bluetooth version 1.1 or higher)
• Supported Bluetooth profiles:
- Headset profile
- Hands-free profile
1
Set your Bluetooth phone to discover the
headset by following your phone's guide.
Typically, the steps involve going to the Settings,
Connection, or Bluetooth menu on your
phone and then selecting the option to discover
Bluetooth devices.
Your phone will find the Samsung WEP180
headset. your headset will be displayed as
Samsung WEP 180/185.
2
Select your headset.
3
When the phone asks if you want to pair with it,
confirm by selecting Yes or OK.
4
Enter the headset passkey or PIN, 0000.