Filter
Top Products
Please read this User’s Guide before
installing, setting up, and using your new product.
www.radioshack.com
Thank you for purchasing your Lamp
Module from RadioShack. You can control
your home’s lamps with the touch of a
button. For added convenience, extra lamp
modules allow you to add additional lights
for expanding your home automation
system.
To test your module, make sure the
lamp’s switch is on and plug the module
into the same wall outlet as your
Controller.
Press the Controller’s On and Off
buttons that correspond to the Unit
Code setting on your lamp module.
If your module turns on and off, move
the Controller and your module to their
permanent location.
If your module does not work, try
plugging your Controller into another
location, or visit your local RadioShack
store for assistance.
61-3002
Lamp Module
©2004. RadioShack Corporation.
All rights reserved. RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
61-3002
06A04
Printed in China
Using a small screwdriver, set your
module’s red House Code dial to the
same letter as your Controller.
Set the Black Unit Code dial to any
unused number.
Plug your lamp’s AC cord into
the module.
Plug your module into the
same wall outlet as your
Controller.
WARNING: To reduce the risk of fi re or shock hazard, do not expose this product to
rain or moisture.
RISK OF ELECTRIC SHOCK.
DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
OR BACK. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
PERSONNEL.
This symbol is intended to alert you to the presence of
uninsulated dangerous voltage within the product’s enclosure
that might be of suffi cient magnitude to constitute a risk of
electric shock. Do not open the product’s case.
This symbol is intended to inform you that important
operating and maintenance instructions are included in the
literature accompanying this product.
Your lamp module only can be used to
control an incandescent lamp rated up to
300W. It is not suitable for other types of
lamps, such as fl uorescent or energy saving
lamps, low voltage lamps, or lamps that
include a dimmer control.
Do not connect an appliance to a lamp
module. It may damage the lamp module
and/or appliance, and could cause a fi re
hazard. Use an appliance module instead.
Unit Code dial
Tip
Use the bottom plug for your
module and the top plug for
your controller.
House Code dial