Filter
Top Products
D-1
D
Programming Mixed Telephone
Typ es
Overview
This appendix provides information about programming from a PARTNER-34D
phone to MLS-model phones and from an MLS-34D phone to PARTNER-model
phones. In these situations, you should be aware that the button that you press at
extension 10 or 11 (the programming extension) is likely to be in a different
location than the button on the phone to which the programming applies (the
target phone). If you are programming from a PARTNER-18D or MLS-18D phone,
the button locations are the same.
You can use the illustrations in this appendix to facilitate programming from one
telephone type to the other. Figure D-1 shows the buttons on the PARTNER-34D
Programming Overlay and the relative location of those buttons on each
MLS-model phone. Figure D-2 shows the buttons on the MLS-34D Programming
Overlay and the relative location of those buttons on each PARTNER-model
phone. (The letters on the PARTNER-34D Overlay in Figure D-1 are printed on
the Overlay. To help you program from an MLS-34D phone, you may want to write
the letters shown on the MLS-34D Overlay in Figure D-2 on your Overlay.)
If you want to program features on specific buttons at target phones, it is
recommended that you:
1. Look at the figure with the overlay that matches the phone at your
programming extension.
2. Find the location of the button in the picture of the target phone.
3. Note the letter associated with that particular button.
4. Find the letter in the picture of the Programming Overlay.
5. Press that button on the programming extension.
For example, if you are using a PARTNER-34D phone at extension 10 and you
want to program Do Not Disturb on the top leftmost button of an MLS-18D phone:
refer to Figure D-1; find the top, leftmost button on the MLS-18D phone; then
press the button labeled M on the PARTNER-34D Programming Overlay.