Filter
Top Products
Feature Reference
5-226
Recall Timer Duration (#107)
Description
This System Programming procedure lets you change the length of the timed
signal, or switchhook flash, generated by the system Recall feature (as well as by
the Recall option used in Auto Dial and Speed Dial numbers). Recall sends this
timed signal over the phone line to the local telephone company or PBX to which
the system is connected. Typically you use the Recall feature to access a PBX,
central office, or Centrex feature, such as Call Waiting. Your local phone
company can tell you the correct setting—for most Centrex systems, the correct
setting is 800 msec. (or 32).
Considerations
You should change the factory setting only under two conditions:
■ If using the system Recall feature has no effect, lengthen the time.
■ If the system is connected to a PBX or Centrex system and Recall drops
calls, shorten the time.
Valid Entries
01 through 80 (25 to 2000 msec. in 25 msec. increments)
18 (450 msec.)
✔
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
as
s and e on system phones.)
To change the duration of the Recall Timer signal:
1. Press
f 0 0 s s # 1 0 7 at extension
10 or 11. A display similar to the following appears:
Recall Timer Duration
18 450-msec
2. Enter a different Recall Timer setting by pressing
D or d. For
example, to increase the Recall Timer setting to 750 msec., press
d
until a display similar to the following appears:
Recall Timer Duration
30 750-msec
Alternatively, you can enter the setting number directly. For example, to set
the Recall timer to 750 msec., press
3 0.