Filter
Top Products
Feature Reference
5-118
—
ChgBat W/PowerOn
or
ReplaceSysBat W/Power On
appears
when PARTNER ACS processor module batteries need to be
replaced. The message may flicker on and off as the batteries near
the low-power threshold. These batteries are used to retain system
programming settings during a power failure. See Chapter 6,
‘‘Troubleshooting’’, for instructions for replacing the batteries.
— Backup-Failure Alarm messages appear if an automatic backup is
unsuccessful. The message is displayed until you clear the alarm (or
until the next successful automatic backup or system restart). See
‘‘Clearing a Backup-Failure Alarm’’ on page 6-3.
Related Features
■ The System Date (#101), System Day (#102), and System Time (#103)
settings are shown as the default display.
■ You can use Display Language (#303) to identify the language in which
messages appear, if the extension has a system display phone.
■ Users can assign a name to their extension. Then, when that extension is
used to make an intercom call, group call, or transferred call, the name and
extension number appear on the system display phone receiving the call.
Similarly, users receiving a transfer return call see the name and extension
number of the person assigned to the extension that did not answer the
transferred call. See Extension Name Display for more information.
Considerations
■ The call timer records the time a user is active on a call. It begins when the
handset is lifted out of the cradle and ends when either the handset is
placed back in the cradle or the call is placed on hold. (This is not the call
duration reported to SMDR. SMDR records the total time the call is in
progress— including the time a call is placed on hold. For more
information, refer to ‘‘Call Reporting Devices (SMDR)’’ on page 4-9.) When a
call is transferred, the timer restarts when the call is answered.
■ The call timer is displayed along with the default display.
■ Most messages (other than the default display and Caller ID) display for
approximately 15 seconds.
■ Marked System Speed Dial Numbers do not display when they are
dialed.
■ The display contrast can be adjusted by pressing * then using the “up”
volume control button to increase the brightness or the “down” volume
control button to decrease the brightness. Adjust the contrast while the
phone is idle and the handset is in the cradle.
■ The angle of the display is adjustable to three positions: low, medium, and
high.