Filter
Top Products
7
A
B
PLACING A CALL
Desk telephone:
Lift phone receiver and then press the call
control button on either the headset (A) or
base unit (B). When you hear the dial tone,
dial number using telephone keypad. If you
do not obtain a dial tone, check that the
configuration dial is set correctly as
described on page 5.
To disconnect, press call control button on
headset or base, then hang up receiver.
Important: If your desk telephone has a
receive volume control, make sure it is set
no higher than mid-range. Too high a
setting could cause audio problems.
Mobile phone:
Dial using your mobile phone’s keypad or
voice- dialling (if supported by your phone).
To disconnect, press call control button
on headset.
Important: You will first need to pair the
headset to your mobile phone. Refer to the
pairing instructions on page 6.
ANSWERING A CALL
Desk telephone:
Lift the telephone’s receiver. Press the call
control button on either the headset (A) or
base (B) to answer the call. To disconnect,
press call control button on headset or base.
Mobile phone:
Press the call control button on the headset (A)
to answer the call. To disconnect, press call
control button on headset.
PLACING & ANSWERING A CALL