Filter
Top Products
Quick-Start Programming Programming Initial ISDN Options
Revised April 2000 DBS-EX23-530 3-9
12. Specify the extension number to call for each ISDN incoming DID
number (page 4-29).
13. Some ISDN lines provide Automatic Number Identification (ANI). This
service is similar to Caller ID by providing the number of the calling party.
For DID calls with ANI information provided, determine if ANI data or
DID data is displayed on the called telephone..
14. If you need to program multiple extensions to ring with DIDs, go to the
instructions under “Slave Cabinet Set-UpMultiple DID Programming.”
If you do not need to program multiple DIDs, you are finished with initial
ISDN programming. Reset the DBS by turning it off then on again.
Multiple DID Programming
1. If you wish to assign the same DID number to more than one station,
enable Multiple DID/DNIS numbering (page 4-33).
2. Assign the ISDN DID numbers to stations (page 4-29).
3. Reset the DBS by turning it off then on again.
Address FF1 9# 3# (0000-9999)# (100-699)#
Address FF3 (Ext Port)# 54# (0-1)#
Options
0=DID data on display
1=ANI data on display
Address FF1 2# 1# 32# (0-1)#
Options
0=Off
1=On
Address FF1 9# 3# (0000-9999)# (10-69 or 100-699)#